Electric and Electronic Products' Fire Hazard Test Methos

The best way to test electric and electronic products' fire hazard, is truly to reproduce the actual existence of conditions, but it is impossible in the most cases. Therefore, according to the current situation, it's better to simulate the actual effects for electric and electronic products' fire hazard test. Needle Flame Test, is used to simulate the fault conditions generated by a small flame effect, and uses the simulation technology for the fire hazard assessment. This section applies to electrical and electronic products, equipment components and parts, but also for solid insulating material or other combustible materials.

Neelde Flame Test is according to IEC60695-11-5, GB/T5169.5-2008,GB4706.1-2005 etc. standards to require use for small flame ignition source simulation project.

Chuangxin CX-Z18 Needle Flame Tester is according to IEC60695-2-2 and IEC60695-11-5, it is applied in the production and quality control department of lighting instrument, hypopiesis electrical apparatus, domestic appliance, machine electric appliance, electrical machine, electronic instrument, electrician instrument and technical equipment. Also, it's for the industry of insulation material, engineering plastics and solid combustible material.

Chuangxin's ZY-3 Needle Flame Tester is widely applied to QA department and lab. Chuangxin will continue feedback good quality products and superior service in the future.